Posts Tagged controller

Above-tank mounted sump design

There are few things that can benefit an aquarium, particularly a salt water aquarium, as much as a good sump. Sumps allow you to create an entire system separate from the main tank that contains all your water processing, heating, conditioning and so on without crowding or visually afflicting the main tank; they allow you to add chemicals and treatments to the water and have them pre-mixed with a large volume of water before they reach your aquarium’s inhabitants, and much more.

But traditional sumps require expensive main tanks with plumbing ports (you can’t add ports to your typical large, inexpensive aquarium, as they are inevitably built with tempered glass), and are mounted underneath the main aquarium where they require bending over to service. Both of these issues go away with this design. You can use any non-ported aquarium as your main tank, so that $500, 75-gallon aquarium with stand from Petsmart you’ve been eying is just fine, and the sump is above the tank, perhaps on a floor above, where you can actually get at it and maintain it.

Here’s my design. You are most welcome to use it.
Read the rest of this entry »

Tags: , , , , , , , , , , , , ,

Using the Pi as an aquarium pump controller

Just a short post to follow up on the how-to Raspberry Pi post. I went into detail on how to get one going, but I never really said what I was doing with the thing. So, in case anyone is curious:

First I installed all the software I wanted. I set the Pi up as a headless (no monitor, keyboard or mouse) network-controlled computer. I installed a wifi dongle so it became a headless, wireless network-controlled computer. And then…
Read the rest of this entry »

Tags: , , , , , ,